TURCK’s line of magnetic cylinder position sensors has been expanded to include the BIM-UNR, a miniature sensor designed to mount within C-groove cylinders with no accessories required. Its dimensions of 2.9 x 4.6 x 18 mm make the BIM-UNR one of the most compact sensors on the market. The sensor can be inserted into a C-groove from the top rather than from the side, simplifying installation. On the sensor’s side is a built-in tab that keeps the sensor in place to facilitate one-handed mounting. The BIM-UNR sensor also incorporates a 1.5 mm hexagon mounting screw that requires only a quarter-turn to securely mount the sensor. As this mounting screw is located near the cable exit, the sensor remains fastened even if the cable is pulled. Since the BIM-UNR sensor is designed to fit inside the C-groove, it is protected from mechanical damage. In addition, the sensor’s active sensing element is located at the bottom of the groove "as close to the magnet as possible" providing reliable detection, especially on short-stroke cylinders. BIM-UNR sensors are also highly immune to EMC interference in accordance with EN 60947-5-2. Click for more information: BIM-UNR-2AP6X-0.2M-RSC 4.4T Data Sheet (PDF) BIM-UNR-AP6X Data Sheet (PDF) For more information, please call your Power/mation sales representative (1.800.843.9859) or info@powermation.com

The FL SWITCH SFNT range of Factory Line switches can be used for quick and cost-effective Ethernet network expansion to the field level. These unmanaged switches allow operation across a wider temperature range than most switches, allowing networks to expand into process industry environments, such as oil/gas, chemical, water/wastewater, wind energy, security, monitoring and some marine segments. Due to the narrow housing design, the switches are suitable for use in control cabinets and junction boxes. The FL SWITCH SFNT switches support the auto negotiation function on the RJ45 ports and offer transmission speeds of 10/100 Mbps. Mixed operation for the connection of segments with different data transmission speeds is also supported. The RJ45 ports offer an auto crossing function, which means it is not necessary to make a distinction between 1:1 and crossover cables. Unused RJ45 ports can be fitted with security caps to provide mechanical protection against unauthorized use. Fiber optic ports are available in an SC or ST format and offer speeds of 100 Mbps. The fiber optic ports extend the segment length to 2000 m Click for more information: Phoenix Contact FL-SFNT Switches Data Sheet (PDF) For more information, please call your Power/mation sales representative (1.800.843.9859) or info@powermation.com